| MODEL |
SI-HPL-1000X500 |
| Distance Between centers x Swing over Bed in mm |
1000x500 |
| Swing Over Bed in mm |
500 |
| Center Height in mm |
220 |
| Swing Over Cross Slide in mm |
270 |
| Swing Over Carriage Wing in mm |
485 |
| Swing in Gap in mm |
0 |
| Width of Gap in Front in mm |
0 |
| Type of Bed |
Inverted V type |
| Length of Bed in mm |
2720 |
| Width of Bed in mm |
415 |
| Gap in Bed in mm |
0 |
| Rapid Transverse of saddle & Cross Slide |
No |
| Maximum Feed Force |
500 |
| Maximum Facing Diameter in mm |
500 |
| Maximum Weight of work piece that can be held between chuck and supported by Live center in kg |
600 |
| Maximum Weight of work piece that can be held between chuck and supported by dead center in kg |
600 |
| Maximum Torque on Spindle in NM |
11 |
| Type of Spindle |
A2-6" |
| Size of Spindle in mm |
165 |
| Taper in Spindle Bore |
Metric-60 |
| Taper Bore in Spindle Sleeve |
Mt-5 |
| Bore in Spindle in mm |
53 |
| Range of Spindle Speed in Forward Direction in rev/min |
20-2040 |
| Range of Spindle Speed in Reverse Direction in rev/min |
60-1430 |
| Type of Chuck |
3 Jaw Self Centered |
| Travel of Cross Slide in mm |
300 |
| Travel of Top Slide in mm |
150 |
| Type of Tool Holder |
Square Shank |
| Tool Shank Size |
25x25 |
| Main Motor Power in kw |
11 |
| Rapid Traverse Motor Power in kw |
0 |
| Type of Cooling |
Natural Air Cooling |
| speed of coolant motor in rev/min |
2800 |
| Noise emitted by Machine in db |
85 |
| Types of power supply |
3phase 440v 50Hz |
| Coolant Pump output in kw |
0.12 |
| Coolant Pump Discharge at maxi.working height |
30 |
| Minimum Chucking Diameter in mm |
5 |
| Maximum Chucking Diameter in mm |
500 |
| Tail Stock Sleeve Diameter in mm |
90 |
| Tail Stock Spindle Taper |
Mt-5 |
| Max.Offset of Tailstock on either side of Center Line in mm |
4 |
| Sleeve Travel Type(Tail Stock) |
Manual |
| Travel of Sleeve in mm |
200 |
| Hardness of Bed Guide Ways in HRC |
48 |
| Lead Screw Diameter in mm |
36 |
| Lead Screw Pitch in mm |
6 |
| Longitudinal Lead Screw Feed Range in mm/rev |
0.04-2.24 |
| Cross feed Range in mm/rev |
0.02-1.12 |
| Metric Thread Range in mm |
0.5-28 |
| British Thread Range in TPI |
1-56 |
| Module Thread Range in mm |
14 |
| Diameteral Pitch Range in mm |
112 |
| Type of Lubrication |
Dry Sump Lubrication |
| Length of Lathe Machine in mm |
2965 |
| Width of Lathe Machine in mm |
1176 |
| Height of Lathe Machine in mm |
1490 |
| Colour of Lathe machine |
Apple Green |
