| TECHNICAL SPECIFICATION |
| MODEL |
SI-DEM-203 |
| Acceptable materials |
Resins such as chemical wood and modeling wax |
| Operating range |
X: min 203.2mm |
| Y: min 152.4mm |
| Z: min 60.5mm |
| Table size |
W: 232.2 mm |
| D: 156.6 mm |
| Loadable work piece weight |
2 Kgs |
| Axis drive |
Stepper Motor |
| Operating Speed |
6-1800 mm/min |
| Software resolution |
0.000039 in/step (RML-1), 0.000039 in/step |
| (NC Code, 0.001 mm/step (NC Code) |
| Mechanical resolution |
0.000998594mm/step |
| Spindle motor |
DC motor Type 380 |
| Spindle rotation speed |
Adjustable 3000 rpm to 7000 rpm |
| Tool chuck |
Cutting tool chuck |
| Tool Change Method |
Collet Method |
| Tool Shank Diameter |
0.250in, 0.125in (6.35, 3.175mm) |
| Operating noise |
During operation 65(dba) & stand at 45(dba) |
| Interface |
USB |
| Power requirements (VAC/A) |
AC 100 to 240 V, 50 Hz, 1.2 A |
| Power consumption (W) |
50W |
| Weight |
19.6 Kg |
| Installation environment |
| Humidity |
35 to 80%RH |
| Ambient pollution degree |
2 (as specified by IEC 60664-1) |
| Short-term temporary overvoltage |
1440 V |
| Long-term temporary overvoltage |
490 V |
| Additional Accessories |
| • Collate 3 mm |
| • End mill 0.4 mm |
| • End mill 0.8 mm |
| • End mill 1 mm |
| • End mill 3 mm |
| • End mill 6 mm |
| • Ball mill 1 mm |
| • Ball mill 6 mm |
| • Engraving bit |
| • Copper Cam Software with installation |
| • Resin Wood 200mm x 200 mm |
| • Copper Clad Plate Laminate Single Side PCB Size : 6x4 inch |
| • Double-sided tape 1 Roll of 12mm X 10mtr |
