| TECHNICAL SPECIFICATION |
| Model - SI-CLM-500 |
| •Cast iron rigid single piece bed with slant saddle Machine construction with casting confirms to FG 300 cast iron single bed structure having 30degree. |
| •Three point leveling system |
| Capacity: |
| Swing over Bed |
500 mm (nominal) |
| Maximum Turning Length |
500 mm (nominal) |
| Standard Turning Dia |
250 mm |
| Interference free turning Dia |
225 mm |
| Maximum Turning Dia |
350 mm |
| Slides: |
| Cross (X-Axis) Travel |
250 mm |
| Longitudinal (Z-Axis) Travel |
500 mm |
| Rapid Feed (X & Z Axis) |
24 m/min |
| Main Spindle: |
| Motor power |
13.5 (S6-40%) / 9 kw (S1 Cont.) |
| Torque (S1) |
114 Nm @ 750 rpm |
| Bar capacity |
50 mm |
| Spindle Nose |
A2-6 |
| Speed Range |
50 to 4000 rpm |
| Turret: |
| Bi- directional servo with hydraulic clamping |
| No. of stations |
8 |
| Max. Boring bar Dia |
40mm |
| Tool Size |
25 x 25mm |
| Accuracy (As per VDI/DGQ3441): |
| Positioning Uncertainty (P) |
0.008 mm |
| Repeatability (Ps) |
0.005 mm |
| Tail Stock: |
| Quill Diameter |
80 mm (nominal) |
| Quill Stroke |
100 mm |
| Thrust (Adjustable) |
500kgf |
| Positioning of tail stock |
Manual |
| Quill travel |
Hydraulic |
| Standard Features: |
| •Controller SINUMERIK 828D (Siemens) |
| •Linear Motion Guideways Roller Type on X & Z Axes |
| •Shop turn software |
| •AC Main Spindle |
| •AC servo digital drives |
| •Directly Coupled Axis Motors |
| •High Precision Roller type LM Guide ways having width of X & Z Axis of 35 mm, |
| •High Precision preloaded ball screw for X & Z Axis having dia. 32 mm & pitch 10 mm |
| •Linear Glass Scale for X & Z Axis |
| •Auto & Manual Coolant System |
| •Centralized & Programmable Lubrication |
| •Hydraulic power pack for chuck, tailstock and turret |
| •Voltage Stabilizer |
| •Isolation transformer |
| •Hydraulic Chuck with soft jaws, 200mm Dia. |
| •90 Deg. Tilting control operator panel |
| •Special provision of movement of guard behind control panel to slide so that there is front access to Tailstock. |
| •Chip Conveyor |
| •Air Gun with connection |
| •Checking of machine as per ISO Geometry Standard and Accuracy testing with Laser Callibration kit |
| •Electrical Cabinet with Air Conditioning Unit |
| •Graphic Simulation & Electronic Hand wheel (MPG) |
| •Manuals |
| •Spares, Service Tool Kit, Electrical Power AC 415V 50 Hz 3 phase |
| Features: |
| •Programmable tail stock with built in center |
| •Tool probe |
| •Coolant gun |
| •Spares for trouble free operation |
